- 您现在的位置：买卖IC网 > Sheet目录370 > ZXLD1350ET5TA (Diodes Inc)IC LED DRIVR WHITE BCKLGT TSOT-5
A Product Line of
Diodes Incorporated
ZXLD1350
30V 350mA LED DRIVER with AEC-Q100
Application Information (Continued)
Soft-start
The device has inbuilt soft-start action due to the delay through the PWM filter. An external capacitor from the ADJ pin to
ground will provide additional soft-start delay, by increasing the time taken for the voltage on this pin to rise to the turn-on
threshold and by slowing down the rate of rise of the control voltage at the input of the comparator. With no external
capacitor, the time taken for the output to reach 90% of its final value is approximately 500 μ s. Adding capacitance increases
this delay by approximately 0.5ms/nF.
The graph below shows the variation of soft-start time for different values of capacitor.
Inherent open-circuit LED protection
If the connection to the LED(s) is open-circuited, the coil is isolated from the LX pin of the chip, so the device will not be
damaged, unlike in many boost converters, where the back EMF may damage the internal switch by forcing the drain above
its breakdown voltage.
Capacitor selection
A low ESR capacitor should be used for input decoupling, as the ESR of this capacitor appears in series with the supply
source impedance and lowers overall efficiency. This capacitor has to supply the relatively high peak current to the coil and
smooth the current ripple on the input supply. A minimum value of 1 μ F is acceptable if the input source is close to the device,
but higher values will improve performance at lower input voltages, especially when the source impedance is high. The input
capacitor should be placed as close as possible to the IC.
For maximum stability over temperature and voltage, capacitors with X7R, X5R, or better dielectric are recommended.
Capacitors with Y5V dielectric are not suitable for decoupling in this application and should NOT be used.
A table of recommended manufacturers is provided below:
Manufacturer
Murata
Taiyo Yuden
Kemet
AVX
Website
www.murata.com
www.t-yuden.com
www.kemet.com
www.avxcorp.com
ZXLD1350
Document number: DS33468 Rev. 8 - 2
16 of 22
www.diodes.com
March 2011
? Diodes Incorporated
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
ZXLD1352ET5TA
IC LED DRIVER HIGH BRIGHT TSOT-5
ZXLD1356DACTC
IC LED DRIVER WHITE BCKLGT 6-DFN
ZXLD1360ET5TA
IC LED DRIVR WHITE BCKLGT TSOT-5
ZXLD1362ET5TA
IC LED DRIVR WHITE BCKLGT TSOT-5
ZXLD1366DACTC
IC LED DRIVER WHITE BCKLGT 6-DFN
ZXLD1370EST16TC
IC LED DRVR HIGH BRIGHT TSSOP-16
ZXLD1371QESTTC
IC LED DRIVER
ZXLD1374EST20TC
IC LED DVR BUCK BOOST 20TSSOP
相关代理商/技术参数
ZXLD1350ET5TA-CUT TAPE
制造商:DIODES 功能描述:ZXLD1350 Series 350 mA 1 MHz SMT LED Driver with Internal Switch - TSOT-23-5
ZXLD1350EV3
制造商:ZETEX 制造商全称:ZETEX 功能描述:circuit diagram and bill of materials
ZXLD1352
制造商:ZETEX 制造商全称:ZETEX 功能描述:350mA LED driver with internal switch and enhanced PWM dimming range
ZXLD1352ET5TA
功能描述:LED照明驱动器 350mA, 30V LED Drver, Int Swtch RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N
ZXLD1356
制造商:DIODES 制造商全称:Diodes Incorporated 功能描述:High accuracy 550mA, 60V LED driver with internal switch
ZXLD1356_10
制造商:DIODES 制造商全称:Diodes Incorporated 功能描述:60V 550mA LED DRIVER with AEC-Q100
ZXLD1356DACTC
功能描述:LED照明驱动器 550mA, 60V LED Drver, Int Swtch RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N
ZXLD1356ET5TA
功能描述:LED照明驱动器 550mA, 60V LED Drver, Int Swtch RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N